But the unit did come up as a mass storage device. Insert the screws into the long slots on the steel plate.
Denim Electrical Home Facebook
Nest please attach the display to its base. With the rf shield removed we can finally see what lies within. If while the display is attached to its base you see a red blinking light then it means that the thermostat is charging but doesnt have enough power to turn on. Attach the display press the display onto the base until it clicks. Last night i finally ran a new run of 187 between the furnace and thermostat to add a c wire and it completely solved the problem. Now that the nest thermostat has been installed you can proceed with setting up its preferences. I got this message please attach the display to its base.
Some time about a year or so ago it started dying on the base and wed have to charge it twice a day. I havent been able to get past this message to install or set anything up. We got our nest 3g on black friday 2016 and it worked just fine throughout the winter. Attach the nest display plate thermostat. It should fit firmly into place. Line up the rectangular connector at the bottom of the display plate with the rectangular port at the bottom of the base plate then push the display onto the base plate.
So ive just purchased and am attempting to install the nest thermostat. Remove the display from the base. Connect wires after all the wires are securely connected push them down to make sure theyre flush with the base. Hard restart the thermostat. Electrical boxes arent common but if you have one secure the steel plate to the electrical box with two of the short steel plate screws. Who wants to use their thermostat as a 38mb jumpdrive.
Whenever i attach it to the base i get the home icon then a message that says to remove the nest from base and reattach it and then it restarts and does the same thing. After a couple of minutes the light will turn light green and should see a message on your display saying please attach the display to its base. With the display off the base wait for the nest to turn back on and display please attach the display to its base press the display for three seconds and release it. Switch the power back on 9. Use the other two short screws to attach the nest base and trim plate to the steel plate. Optional in most homes optional in most homes.
Attach the nest base pull the wires through the center of the base then attach it to the wall with the screws. The thermostat shows a notification that says please remove the thermostat from its base then reattach it the thermostats display wont light up and unresponsive you may also observe a blinking red or green light above the display the thermostat cant control the corresponding heating and cooling units. After the 3 second hold the display should then read nest is restarting back in a bit. After using the nest and its accompanying website i certainly hope so.
Gallery of Nest Please Attach The Display To Its Base
